SKF 6026-2Z Metal Shielded Single Row Deep Groove Ball Bearing 130x200x33mm

The SKF 6026-2Z shielded deep groove ball bearing combines a large 130mm bore with a comparatively compact 200mm outside diameter and 33mm width. Its 60 series geometry is particularly useful where machinery designers need to accommodate a substantial shaft without increasing the bearing housing to the dimensions of a heavier series. The single row deep groove construction supports predominantly radial loads and axial forces in both directions, subject to the bearing's operating limits. SKF specifies a basic dynamic load rating of 112kN and a basic static load rating of 100kN. These ratings provide a basis for assessing fatigue life and loading in industrial drive systems. The SKF Explorer design and sheet metal cage support consistent rotational performance in properly mounted and lubricated equipment.

The 2Z designation identifies a metal shield on each side of the bearing. Unlike rubber contact seals, these shields do not rub continuously against the inner ring, helping reduce sealing friction while retaining factory-applied grease. They offer protection against larger particles but are less effective than contacting seals against fine dust, water and liquid contamination. SKF lists a 7,000rpm reference speed and a 3,400rpm limiting speed for this configuration; these are distinct catalogue parameters, and actual permissible operating speed must be assessed against load, lubrication and temperature. Normal (CN) radial internal clearance should also be checked against the effects of interference fits and thermal expansion. For replacement work, confirm the complete 6026-2Z designation, particularly where C3-clearance or rubber-sealed variants are also available.

Typical Applications:

Large industrial electric motor assemblies

Industrial gearboxes and mechanical transmissions

Heavy-duty conveyor drive shaft systems

Industrial fans and air-handling equipment

Large rotating machinery and processing equipment